Membrane Air Spring Isolators

Membrane Air Spring Isolators

The Unick Membrane Air Spring Isolator is constructed in cast aluminium body. It consists of a air chamber that is sealed with a reinforced, flexible diaphragm. When compressed air inserted through the inlet valve, the isolator supports its payload using a piston which is located on the top of the diaphragm. We can calculate the load capacity of the isolator by using the pressure on the diaphragm and effective area of the diaphragm. Permissible Temperature Range is -20deg C to +90 deg C.

The typical pneumatic isolator design incorporates dual air chambers. It has very low level natural frequency. It can be removed the vibration frequency below 2 Hz.

 

 

Applications:

Coordinate Measuring Machines (CMM)

Metrology Inspection Devices.

Electronic Microscope.

Spectrometers.

Roughness Tester.

Hardness Tester.

Analytical Balance.

Atomic Absorption Spectrophotometers.

Roundness Tester.

Microscope.

Galvanometer.

Atomic Force Microscope.

Profile Projectors etc.

 

Exercise:

In case of Sensitive Equipments like Coordinate Measuring Machine (CMM), We can achieve highly effective vibration isolation by using “Cradles” or “Custom designed Rigid Frames”. Cradles increase the stability of self levelling pneumatic isolation system by lowering the center of gravity. A cradle support frame is used to position the membrane air spring isolators achieve the reduction in passive vibration. Second, it is also used when a machine base cannot be modified to place the isolators and then rigid frame is required.

Membrane Air Spring Isolators

    Advantages:

REQUEST To QUOTATION